Chapter 7 SCPI
SCPI command errors
258 WCDMA Options Version 6.20
320 Save/recall memory lost.
330 Function not supported.
350 Queue overflow.
362 There needs to be an active call in order to start the codec
option.
364 No audio hardware. The audio option would be required to
complete a command, but it is not installed.
365 No codec hardware. The codec option would be required to
complete a command, but it is not installed.
370 No results available.
371 Fetch: timeout occurred.
372 Fetch: no BER synchronization.
373 Fetch: arb data.
374 Measurement task error.
375 Error in burst data encountered.
376 ACPM receive error.
377 Autotemplate error.
378 Setting value for modulation spectrum out of range.
399 Invalid error code.
401 General CDMA measurement error: Invalid return code for
sample acquisition.
402 CDMA Measurement error: Signal level too high for current
input attenuation.
403 CDMA Measurement error: Signal level dropped below valid
level during acquisition.
407 CDMA Measurement error: Sample acquisition RAM failure.
408 CDMA Measurement error: Signal level below minimum
accuracy specification.
411 CDMA Measurement error: DSP EEPROM error. Default cor-
rection data loaded, measurement accuracy not verified.
413 CDMA Measurement error: synchronization to mobile sig-
nal failed.
415 CDMA Measurement error: Cannot trigger on mobile signal.
To Next Page
Loading...
