WILLTEK 4403 - Page 292

Appendix A SCPI Command Reference
SYSTem subsystem
270 WCDMA Options Version 6.20
:SYSTem:COMMunicate:TCPip:MOUNt
:SYSTem:COMMunicate:TCPip:DHCP
:SYSTem:COMMunicate:TCPip:WCDMa:ADDRess
:SYSTem:COMMunicate:TCPip:WCDMa:NETMask
Query
Reads and returns the current setting of the terminator used by TCPIP as explained
above.
Example
SYST:COMM:TCP:TERM CRLF sets the line terminator for SCPI commands via
LAN to CR (Carriage Return) followed by LF (Line Feed).
Syntax
:SYSTem:COMMunicate:TCPip:MOUNt <string1> <string2>
Parameters
string1 defines the network address which shall be mounted as a device for
remote control. The maximum allowable length of the string is 255 characters.
string2 is the symbolic device address used in SCPI programming. The maximum
allowable length of string2 is 25 characters. The default is "server".
Description
This command mounts a server disk as a 4400 device which can be used to load or
save data to/from. See section I/O Configuration for more details.
Query
Reads and returns the last settings for the mount path and the corresponding local
name as explained above.
Example
:SYST:COMM:TCP:MOUNt "unixpc/disk2/results","resdir"
Syntax
:SYSTem:COMMunicate:TCPip:DHCP <PredefExp>
Parameters
PredefExp can take on one of the following values: ON or OFF. The default is
OFF.
Description
The command turns DHCP on or off. See section I/O Configuration for more details.
Query
Reads and returns the current setting of DHCP operation.
Example
:SYST:COMM:TCP:DHCP ON sets the software to use DHCP.
Syntax
:SYSTem:COMMunicate:TCPip:WCDMa:ADDRess <string>
Parameters
string
is a string only containing the IP address for the 4400 WCDMA board.
Description
This command sets the IP address of the 4400 WCDMA board.
Query
Reads and returns the current setting of the IP address as explained above.
Example
SYST:COMM:TCP:WCDMA:ADDR "192.16.16.114" sets the IP address to a
defined value.
Syntax
:SYSTem:COMMunicate:TCPip:WCDMa:NETMask <string>
Parameters
string
is a string only containing the net mask for the 4400 WCDMA board.
Description
This command sets the Netmask of the 4400 WCDMA board.