WILLTEK 4403 - Page 330

Appendix A SCPI Command Reference
CONFigure subsystem
308 WCDMA Options Version 6.20
:CONFigure:WCDMa:NB:ATTach
:CONFigure:WCDMa:NB:SPLoop
:CONFigure:WCDMa:NB:BAND
:CONFigure:WCDMa:NB:DLUarfcn
Syntax
:CONFigure:WCDMa:NB:ATTach <PredefExp>
Parameters
PredefExp
is one of the following predefined expressions: OFF|ON. The default is
OFF.
Description
Forces the UE to re-register even though it was registered to the cell before getting
switched off.
Query
The query form of this command returns the current setting for PredefExp
.
Example
:CONF:WCDMA:NB:ATT ON
:CONF:WCDMA:NB:ATT?
Value returned in this example:
ON.
Syntax
:CONFigure:WCDMa:NB:SPLoop <PredefExp>
Parameters
PredefExp
is one of the following predefined expressions: OFF|ON. The default is
OFF.
Description
Activates or disactivates the speech loopback mechanism to give an audible indica-
tion of the speech call.
Query
The query form of this command returns the current setting for PredefExp
.
Example
:CONF:WCDMA:NB:SPL ON
:CONF:WCDMA:NB:SPL?
Value returned in this example:
ON.
Syntax
:CONFigure:WCDMa:NB:BAND <PredefExp>
Parameters
PredefExp is one of the following predefined expressions:
BAND1|BAND2|BAND3|BAND4|BAND5|BAND6|BAND14|BAND34. The
default is BAND1
.
Description
This command sets the actual WCDMA operating band.
Query
The query form of this command returns the current setting for PredefExp
.
Example
:CONF:WCDMA:NB:BAND BAND2
Value returned in this example: BAND2
.
Syntax
:CONFigure:WCDMa:NB:DLUarfcn <Int1>
Parameters
Int1 is an integer number. The minimum value is 412, the maximum value 10838.
The default value is 10700.
Description
This command sets the WCDMA Downlink channel.
Note: This command also sets the Uplink channel to the corresponding channel.