WILLTEK 4403 - Page 331

Appendix A SCPI Command Reference
CONFigure subsystem
WCDMA Options Version 6.20
309
:CONFigure:WCDMa:NB:ULUarfcn
:CONFigure:WCDMa:MEASure:UEReport:TRCH
:CONFigure:WCDMa:MEASure:RFTX:INNErloop:SEQuence
:SELEct
Query
The query form of this command will return the current setting of the Willtek 4400.
The string delivered back will contain one integer number.
Example
:CONF:WCDMA:NB:DLU 5000
:CONF:WCDMA:NB:DLU?
Value returned in this example: 5000
.
Syntax
:CONFigure:WCDMa:NB:ULUarfcn <Int1>
Parameters
Int1 is an integer number. The minimum value is 12, the maximum value 9888.
The default value is 9750.
Description
This command sets the WCDMA Uplink channel.
Note: This command also sets the Downlink channel to the corresponding channel.
Query
The query form of this command will return the current setting of the Willtek 4400.
The string delivered will contain one integer number.
Example
:CONF:WCDMA:NB:ULU 5000
:CONF:WCDMA:NB:ULU?
Value returned in this example:
5000.
Syntax
:CONFigure:WCDMa:MEASure:UEReport:TRCH
Parameters
PredefExp is one of the following predefined expressions:
RAB1|RAB2|RAB3|SRB. The default is RAB1.
Description
Defines on which kind of Transport Channel the BLER estimation within the UE
applies.
Query
The query form of this command returns the measurement that has been choosen.
Example
:CONF:WCDMA:MEAS:UEReport:TRCH RAB2
:CONF:WCDMA:MEAS:UEReport:TRCH?
Returned string in this example: RAB2
.
Syntax
:CONFigure:WCDMa:MEASure:RFTX
:INNErloop:SEQuence:SELEct <PredefExp>
Parameters
PredefExp is one of the following predefined expressions:
ILS1|ILS2|ILS33|ILS4|ILS5|SEQE|SEQF|SEQG|SEQH
Default is ILS1
.
Description
This command selects the inner loop power control sequence.
Query
The query form of this command will return the current selected inner loop power
control sequence.
Example
:CONF:WCDM:MEAS:RFTX:INNE:SEQ:SELE SEQE
:CONF:WCDM:MEAS:RFTX:INNE:SEQ:SELE?
Value returned in this example: "SEQE"
.