WILLTEK 4403 - Page 340

Appendix A SCPI Command Reference
CALL subsystem
318 WCDMA Options Version 6.20
:CALL:WCDMa:ACTive
:CALL:WCDMa:NB:ORIGinate
:CALL:WCDMa:NB:RELease
:CALL:WCDMa:NB:LOOPback[:STARt]
Query
This query gets the calculated Preamble Initial Power.
Example
:CALL:WCDM:POW:PREA?
Value returned in this example: -20.0
Syntax
:CALL:WCDMa:ACTive?
Parameters
There are no parameters.
Description
There is only a query form of this command available.
Query
This query checks if a call is established. Possible returns are NO|YES
.
Example
:CALL:WCDM:ACT?
The string delivered is, for example: "YES"
.
Syntax
:CALL:WCDMa:NB:ORIGinate
Parameters
There are no parameters.
Description
Initiates a call setup by the base station (Willtek 4400).
Query
There is no query form of this command available.
Example
:CALL:WCDM:NB:ORIG
This command will initiate a NB-originated call in the 4400 (i.e. the mobile phone will
be called)
.
Syntax
:CALL:WCDMa:NB:RELease
Parameters
There are no parameters.
Description
This command will make the Willtek 4400 terminate the ongoing call.
Query
There is no query form of this command available.
Example
:CALL:WCDM:NB:REL
This command will release the call.
Syntax
:CALL:WCDMa:NB:LOOPback[:STARt]
Parameters
There are no parameters.
Description
This command will set the UE into loopback test mode.
Query
This query checks if the UE is in loopback mode. Possible returns are
ON|OFF.