WILLTEK 4403 - Page 385

Appendix A SCPI Command Reference
FETCh Subsystem
WCDMA Options Version 6.20
363
:FETCh:GPRS:MULTIslot:RFSPectrum:ACPM:TRANsient?
:FETCh:WCDMa:LAST
:FETCh:WCDMa:RFTX:FREQ:ERRor
Parameters
There are no parameters with this command.
Description
Only the query form of this command is available.
Query
Returns int1 times the number of active uplink slots followed by 23 float values per
time slot. int1 is the number of measurements defined in the respective
MEAS:GPRS:ARRay command. For the meaning of the 23 float values per slot, see
:MEAS:GPRS:ACPM:MODulation.
Example
:CONF:GPRS:MSTA:MSL 2
:MEAS:GPRS:ARR:MULT:RFSP:ACPM:MOD 3
:FETCh:GPRS:MULT:RFSP:ACPM:MOD?
Syntax
:FETCh:GPRS:MULTIslot:RFSPectrum:ACPM:TRANsient?
Parameters
There are no parameters with this command.
Description
Only the query form of this command is available.
Query
Returns int1 times the number of active uplink slots followed by 27 float values per
time slot. For the meaning of the 27 float values, see :MEAS:GPRS:ACPM:TRAN-
sient.
Example
:CONF:GPRS:MSTA:MSL 2
:FETCh:GPRS:MULT:RFSP:ACPM:TRAN?
Syntax
:FETCh:WCDMa:LAST
Parameters
There are no parameters.
Description
Only the query form is supported.
Query
Returns exactly the same values returned by the last FETCh: or MEASure:
query.
Example
:FETC:WCDM:LAST?
Syntax
:FETCh:WCDMa:RFTX:FREQ:ERRor?
Parameters
There are no parameters.
Description
Only the query form is supported.
Query
The command returns the results of the
:MEASure:WCDMa:CONT|ARRay:RFTX:FREQ:ERR measurement command.
Example
:FETC:WCDM:RFTX:FREQ?
Returns the measured frequency error, e.g.
-7.834.