Maintenance0002−1/A1
Table of Contents
Winterthur Gas & Diesel Ltd.
4/ 4
2016-11
Piping Group 8
Exhaust Waste Gate (Low-Load Tuning) 8135−1/A1..................................................
SCR Valve − Removal and Installation 8155−1/A1....................................................
HP Servo Oil Pipe: Removal, Grind the Sealing Faces and Installation (with HAWE SOP) 8447−1/A1.....
Hydraulic Pipe − Exhaust Valve Drive: Removal, Grind the Sealing Faces and Installation 8460−1/A1....
HP Fuel Pipe (Injection Valve): Removal, Grind the Sealing Faces and Installation 8733−1/A1...........
HP Fuel Pipe: Removal, Grind the Sealing Faces and Installation 8752−1/A1...........................
Crank Angle Sensor Unit, Tools Group 9
Crank Angle Sensor Unit: Replacement of Proximity Sensor 9223−1/A1...............................
Relief Valve on Cylinder Cover: Blow-off Pressure Check 9308−1/A1..................................
Tools: Description of Tool Categories 9403−1/A1.....................................................
Hydraulic Pre-tensioning Jacks and Pumps
Configuration and Application 9403−2/A1.........................................................
Overview, Storage, Servicing and Maintenance 9403−3/A1..........................................
General Instructions 9403−4/A1..................................................................
Tool List 9403−5/A1................................................................................
Standard Tools Pages 1 to 35...................................................................
Recommended Special Tools Pages 36 to 38......................................................
To Next Page
