Xerox Phaser 6125

3-22 Phaser 6125/6130 Color Laser Printer Service Manual
Error Messages and Codes
Out of Memory
The printer memory is full and cannot continue to print. Print job requires
additional memory.
Applicable Chain Link
■ Chain Link 016-718: Out of memory
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
4 Reseat plugs and jacks on the Image
Processor Board (refer to the
procedure on page 8-60).
Does the error still occur when the
power is turned OFF and ON?
Go to step 4. Complete
5 Re-download the correct file from the
Xerox web site.
Does the error still occur when the
power is turned OFF and ON?
Replace the
Image
Processor Board
(page 8-60).
Complete
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL8.1.9
■ Memory Card (Option)
“Map 3 - LVPS, Drive Motors, I/P Board, AC
Power” on page 10-10
“Controller” on page 10-31
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the required memory for the
print job.
2.Print a small size file (like a
Windows test print).
3.Does the error still occur?
Go to step 2. Add memory
card or separate
the print job.
2 Reseat the memory card. Does the
error still occur?
Go to step 3. Complete.
Troubleshooting Procedure (continued)
Step Actions and Questions Yes No