Xerox Phaser 6125

3-26 Phaser 6125/6130 Color Laser Printer Service Manual
Error Messages and Codes
RAM Error
The printer controller has detected a DIMM slot RAM error.
Applicable Chain Link
■ 116-316: RAM Error (DIMM Slot RAM W/R Check Fail)
■ 116-320: RAM Error (DIMM Slot RAM Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL8.1.9
■ Memory Card (Option)
“Map 3 - LVPS, Drive Motors, I/P Board, AC
Power” on page 10-10
“Controller” on page 10-31
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Verify RAM is compatible with the
printer. If RAM was recently installed,
it may not be compatible.
Is RAM compatible?
Go to step 2. Replace the
Memory Card.
2 Check the Memory Card for correct
installation.
Is the Memory Card correctly
installed?
Go to step 3. Complete.
3 Replace the Memory Card.
Does the error still occur?
Replace the
Image
Processor Board
(page 8-60).
Complete.