Phaser 6125/6130 Color Laser Printer Service Manual 3-33
Error Messages and Codes
26 Check the connectors of the Drive
Clutch Assembly (Regi Clutch) for
connection
Check the connections between the
MCU Board and Drive Clutch
Assembly.
Are P/J26 and P/J262 connected
correctly?
Go to step 27. Reconnect the
connector(s) P/
J26 and/or P/
J262 correctly.
27 Check the power to the Drive Clutch
Assembly
Disconnect J26 from the MCU Board.
Is the voltage across P26-4 <=>
ground on the MCU Board, about +24
VDC when the Front Cover interlock
switch is pushed?
Go to step 28. Replace the
MCU Board
(page 8-59).
28 Check the Drive Clutch Assembly for
resistance
Disconnect P/J262 of the Drive Clutch
Assembly.
Is the resistance across J262-1 and
J262-2 approximately 280-ohm?
Replace the
MCU Board
(page 8-59).
Replace the
Drive Clutch
Assembly Kit
(page 8-21).
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No
To Next Page
Loading...
