Xerox Phaser 8400

8-18 Phaser 8400/8500/8550 Color Printer
Head Tilt Solenoid
(Phaser 8500/8550 only)
(PL 4.12)
1. Remove the left side cover (see page 8-7) and the right side cover (see page 8-6).
2. Remove the printhead (see page 8-12).
3. Lower the wiper blade to its lowest position.
4. From the chassis left side, disconnect the connector attached to the head tilt
solenoid.
5. Remove the screw from the head tilt solenoid, then swing the unit out to the left
until the solenoid is free from the chassis.
Note
Be careful not to lose the restraining spring from the unit.
Replacement Notes:
Caution
To ensure proper operation of the printhead, observe the following order
when reinstalling the head tilt solenoid.
1. Insert the plastic end of head tilt solenoid into the chassis, swing to the right and
replace the screw in the chassis.
2. Using a screwdriver from the right side of the chassis, turn the lower screw of the
process drive clockwise until you hear the tilt head solenoid snap into place.
s8500-079
Head Tilt Solenoid