Service Parts Disassembly 8-31
Transfix Camshaft Assembly
(PL 3.8)
1. Perform Steps 1 through 7 (remove Transfix Load Arms) of the Transfix Load
Module removal procedure (see page 8-26).
2. Remove the Process Drive Gearbox assembly (see page 8-51).
3. Slide the shaft to the right (1) and make sure the bearing slides over to the gear,
move the shaft down and slightly to the right (2) and then up and to the left (3) to
remove it from the printer chassis cavity.
s8500-093
1
2
3
Transfix Camshaft
To Next Page
Loading...
