Service Parts Disassembly 8-7
Left Side Cover
(PL 1.9)
1. Remove the Control Panel Cover.
2. Open the Exit Cover and Front Door.
3. Remove the rear screw.
4. Release the latching tabs (see Covers figure on page 8-4) and remove the Left
Side Cover.
Exit Cover
(PL 1.7)
1. Remove the Right and Left Side Covers.
2. The exit cover (see Covers figure on page 8-4) will now just lift off the printer.
Replacement Note:
Note
Lift the upper exit guide slightly, and engage the pins on the upper exit guide
with the slots on the Exit Cover before inserting the cover hinge pins into the
pivot points in the printer frame.
To Next Page
Loading...
Need help?
General