Xerox Phaser 8400 Service Manual

7-4 Phaser 8400/8500/8550 Color Printer
Pick Roller Cleaning Method
Tray 1
Tray 1 pick roller can be cleaned with an alcohol moistened swab.
1. Open the front cover.
2. Rotate the roller and clean it with an alcohol-moistened swab.
3. Rotate the roller so that the flat side is facing down.
4. Close the front cover.
Trays 2-4
Use off-the-shelf clear packaging tape and follow the procedures listed below to clean
the pick roller and pick pad for Trays 2-4. This cleaning method has been found to be
extremely effective for removing debris. Isopropyl alcohol, while effective, tends to
smear the debris, rather than remove it.
1. Remove the tray with the paper-picking or paper jamming problem (Tray 2, 3, or
4).
2. Peel off a strip of tape. Stretch the tape across the table with the sticky side up.
Fasten it to the table at both ends.
3. Remove the roller.
4. Roll the roller across the tape to remove the debris from the roller.
5. Locate a clean section of the tape, rub it onto the surface of the pick pad for the
paper tray, then remove it.
6. Replace the roller.
7. Reinsert the tray.
Drum Temperature Sensor
With a dry swab, clean any buildup around the drum temperature sensor. You can
access the sensor through the opened exit cover. Also, make sure the sensor rides
evenly on the drum surface. You can remove the sensor, if necessary, to clean under it.

Xerox Phaser 8400 Specifications

General

Brand	Xerox
Model	Phaser 8400
Category	Printer
Language	English