Xerox Phaser 8400 Service Manual

Service Parts Disassembly 8-41
Paper Guides
Inner Simplex Guide
(PL 3.1)
1. Open the printer Front Door to access the guide.
2. Using a small flatblade screwdriver, pry inward on one retainer to remove it from
the mounting post then remove the other retainer.
3. Slide the guide down and forward to remove.
Replacement Note:
Note
The fingers on the Inner Simplex Guide, go over the segmented roller. First
snap the left retainer into place, then the right.
Lower Inner Duplex Guide
(PL 3.2)
1. Open the Front Door of the printer.
2. Pull out on the tabs at the bottom of the guide and let the guide swing free.
3. Pry inward (toward the center of the printer) on the right upper retainer until it is
free of the mounting boss and remove the guide.
Lower Exit-Guide Assembly with Strip Flag
(PL 3.3)
1. Open Exit Door.
2. Lift upward on the center of the guide, then flex the left retainer inward to
remove it.
3. Remove the right retainer and remove the guide.
Outer Duplex Paper Guide With Sensors (Safety Interlocks)
(PL 3.4)
1. Remove the Control Panel (see page 8-6).
2. Remove 4 screws and remove the guide.

Xerox Phaser 8400 Specifications

General

Brand	Xerox
Model	Phaser 8400
Category	Printer
Language	English