YASKAWA CR700

11.2 A: Initialization Parameters
576 YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
No. Name Optimal Value
C1-01 Acceleration Time 1 3.0 s
C1-02 Deceleration Time 1 3.0 s
C1-09 Fast Stop Time 2.0 s
d1-01 Reference 1 5.00 Hz
d1-02 Reference 2 25.00 Hz
d1-03 Reference 3 50.00 Hz
E1-03 V/f Pattern Selection F: Custom
F1-05 Encoder 1 Rotation Selection 1: A pulse leads with Forward run command
H2-01 Term M1-M2 Function Selection 21: Brake Release Command
H2-02 Term M3-M4 Function Selection 1: Zero Speed
H3-06 Terminal A3 Function Selection F: Not Used (Through Mode)
L2-03 Minimum Baseblock Time 0.1 s
L3-04 Stall Prevention during Decel 0: Disabled
L8-05 Input Phase Loss Protection Sel 1: Enabled
L8-07 Output Phase Loss Protection Sel 1: Fault when One Phase is Lost
L8-38 Carrier Frequency Reduction 1: Enabled below 6 Hz
L8-41 High Current Alarm Selection 1: Enabled
S1-01 Brake Release Frequency (FWD) 0.0 Hz
S1-02 Brake Release Frequency (REV) 2.0 Hz
S1-03 Brake Delay Frequency 0.0 Hz
S1-04 Brake Delay Time 0.00 s
S1-09 Torque Compensation (FWD) 0%
S1-12 Brake Hold Frequency (FWD) 3.0 Hz
S1-13 Brake Hold Frequency (REV) 3.0 Hz
S1-14 Slip Prevention Frequency 0.0 Hz
S1-15 Slip Prevention Time 0.00 s
S1-16 Sequence Fault SE1 Detect Time 0.30 s
S1-17 Sequence Fault SE2 Detect Time 1.00 s
S1-18 Sequence Fault SE3 Detect Time 0.50 s
S1-19 Sequence Fault SE4 Detect Time 0.50 s
S1-54 Brake Sequence Selection 1: Enabled
Table 11.7 Parameters Saved as User Parameters with the Closed Loop Crane (Hoist) Preset
User Parameter No. Parameter No. Saved Name
A2-01 b1-01 Frequency Reference Selection 1
A2-02 b2-01 DC Injection/Zero SpeedThreshold
A2-03 C1-01 Acceleration Time 1
A2-04 C1-02 Deceleration Time 1
A2-05 d1-01 Reference 1
A2-06 d1-02 Reference 2
A2-07 d1-03 Reference 3
A2-08 F1-01 Encoder 1 Pulse Count (PPR)
A2-09 F1-05 Encoder 1 Rotation Selection
A2-10 L1-01 Motor Overload (oL1) Protection