Mechanical & Electrical Installation
2
2.9 Change the Drive Enclosure Type
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual 59
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
A - Hooks
B - Back side of top protective cover
C - Temporary placement holes
D - M4 × 8 pan head screws
Figure 2.52 Install the Top Protective Cover
■ Install the Conduit Bracket
• Remove the drive hanging brackets before you install the kit.
• Remove the knock-out holes on the UL Type 1 base before you install it to the drive.
Refer to
Remove the Knock-Out Holes on page 51 for more information.
1. Use the included screws to assemble the stay brackets.
Tighten the screws to a correct tightening torque:
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
A - Stay brackets B - M4 × 8 pan head screws
Figure 2.53 Install the Stay Brackets
2. Use the included screws to install the UL Type 1 base on the stay brackets.
Tighten the screws to a correct tightening torque:
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
To Next Page
Loading...
