11.8 H: Terminal Functions
718 YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
OFF : The output current/torque exceeds the torque value set with S6-02 [Overtorque Detection
Level 1] and remained in this state longer than the time set with S6-03 [Overtorque Detection
Time 1].
Note:
Refer to
Overtorque Detection on page 214 for details.
■ 18: Torque Detection 2 (N.O.)
Setting Value Function Description
18 Torque Detection 2 (N.O.)
The terminal activates when the drive detects overtorque.
ON : The output current/torque exceeds the torque value set with S6-05 [Overtorque Detection
Level 2] and remained in this state longer than the time set with S6-06 [Overtorque Detection
Time 2].
Note:
Refer to
Overtorque Detection on page 214 for details.
■ 19: Torque Detection 2 (N.C.)
Setting Value Function Description
19 Torque Detection 2 (N.C.)
The terminal deactivates when the drive detects overtorque.
OFF : The output current/torque exceeds the torque value set with S6-05 [Overtorque Detection
Level 2] and remained in this state longer than the time set with S6-06 [Overtorque Detection
Time 2].
Note:
Refer to
Overtorque Detection on page 214 for details.
■ 1A: During Reverse
Setting Value Function Description
1A During Reverse
The terminal activates when the motor operates in the reverse direction.
ON : The motor is operating in the reverse direction.
OFF : The motor is operating in the forward direction or the motor stopped.
Figure 11.67 Reverse Operation Output Time Chart
■ 1B: During Baseblock (N.C.)
Setting Value Function Description
1B During Baseblock (N.C.)
The terminal deactivates during baseblock. When the drive is in baseblock, the drive output transistor stops switching and does
not make DC bus voltage.
ON : The drive is not in baseblock.
OFF : During baseblock
To Next Page
Loading...
