YASKAWA CR700 - Page 853

EZZ023535
18 / 35
Figure 3.9 Forward Run - Alignment - Slave ahead of Master
Note: The Alignment input is edge triggered. (At least 15 ms.)
Figure 3.10 Continuous Align (SA-61 = 3)
Note: The Alignment input is edge triggered. (At least 15 ms.)
Align Trim Rate
(SA-62)
Figure 3.8 Forward Run - Alignment - Master ahead of Slave
Align Trim Rate
(SA-62)
Master run input
Slave run input
Alignment input
Master Trigger input
Slave Trigger input
Master motor speed
Slave motor speed
Align complete output
In Alignment output
Master run input
Slave run input
Alignment input
Master Trigger input
Slave Trigger input
Master motor speed
Slave motor speed
Align complete output
In Alignment output
SA-62
SA-62
SA-62
Master run input
Slave run input
Alignment input
Master Trigger input
Slave Trigger input
Master motor speed
Slave motor speed
Align complete output