YASKAWA NX100 Instructions

10.2 Upgrade Procedure
10-3
3. Restart of the NPP01 Software (Upgrade Completed)
The NPP01 software is restarted when the upgrade of NPP01 software is completed
(in the same manner as power-on procedure). The following initial window appears
approx. 40 seconds later. (If the initial window is not displayed properly, turn ON the
main power again.)
If the power is turned OFF during the upgrade process of NPP01, a window to start
upgrade operation reappears when restarting the NPP01 software. Perform the procedure
in " 10.2 Upgrade Procedure ".
GETTOOL P000 TL#(0)
=>
SETUP
CF
FD/CF
B001
VARIABLE
In Out
IN/OUT
ROBOT
SYSTEM INFO
ARC WELDING
Short CutMain Menu
Turn on servo power
JOB
DOUT
MOVE
END
DISPLAY SETUP
A
a
NOTE

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C