YASKAWA NX100 Instructions

vii
Explanation of Warning Labels
The following warning labels are attached to the manipulator and NX100.
Fully comply with the precautions on the warning labels.
• The label described below is attached to the manipulator.
Observe the precautions on the warning labels.
Failure to observe this caution may result in injury or damage to equipment.
Refer to the manipulator manual for the warning label location.
• The following warning labels are attached to NX100.
Observe the precautions on the warning labels.
Failure to observe this warning may result in injury or damage to equipment.
WARNING
WARNING
Do not enter
robot
work area.
WARNING
Moving parts
may cause
injury
Internal Breaker
WARNING
High Voltage
Do not open the door
with power ON.
WARNING
High Voltage
Do not ope the cover.
WARNING
May cause
electric shock.
Ground the earth
terminal based on
local and national
electric code.

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C