Chapter 6 Interface Configuration
Confidential and Proprietary Information of ZTE CORPORATION 101
TABLE 104 CONFIG TERMINAL COMMAND
Command
Format
Command
Mode
Command Function
config
terminal
Exec Enters into global configuration
mode
Result: This enables to enter into global configuration mode.
2. To enter into ATM interface configuration mode, use
interface <interface-number> command in global
configuration mode, as shown in
Table 105.
TABLE 105 INTERFACE CONFIG COMMAND
Command
Format
Command
Mode
Command Function
interface
<interface-
number>
global config
This enters into interface
configuration mode
Result: This enables to enter into interface configuration
mode.
3. To create ATM PVC, use atm pvc <vpi> <vci> command in
interface configuration mode, as shown in
Table 106.
TABLE 106 PVC COMMAND
Command
Format
Command
Mode
Command Function
atm pvc
<vpi> <vci>
Interface This creates PVC
4. To configure an IP address of an interface, use ip address
<ip-address> <net-mask> [<broadcast-address>]
command in interface configuration mode, as shown in
Table
107.
TABLE 107 IP ADDRESS COMMAND
Command
Format
Command
Mode
Command Function
ip address
<ip-
address>
<net-mask>
[<broadcast-
address>]
Interface
This configures an ip address of
an interface
Result: This configures an ip address of an interface.
5. To enable oam F5 management of PVCs, use oam-pvc
manage [<frequency>] command in interface configuration
mode, as shown in
Table 108.
To Next Page
Loading...
