Zte ZXR10 GER - Page 128

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
106 Confidential and Proprietary Information of ZTE CORPORATION
2. To create a smartgroup interface and to enter into it, use
interface <interface-number> command in global
configuration mode, as shown in
Table 115.
TABLE 115 SMART GROUP INTERFACE COMMAND
Command
Format
Command
Mode
Command Function
interface
<interface-
number>
global config
This creates a smartgroup
interface and enters into
interface configuration mode
Result: This enables to create smart-group and to enter into
it.
3. To configure an IP address of an interface, use ip address
<ip-address> <net-mask> [<broadcast-address>]
command in interface configuration mode, as shown in
Table
116.
TABLE 116 IP ADDRESS COMMAND
Command
Format
Command
Mode
Command Function
ip address
<ip-
address>
<net-mask>
[<broadcast-
address>]
Interface
This configures an ip address of
an interface
Result: This configures an ip address of an interface.
4. To add Ethernet interfaces into smartgroup, use
smartgroup <interface-number>command in interface
configuration mode, as shown in
Table 117.
TABLE 117 SMART-GROUP ETHERNET COMMAND
Command
Format
Command
Mode
Command Function
smartgroup
<interface-
number>
Interface
This adds Ethernet interfaces
into smartgroup
Result: This sets Ethernet interfaces into smartgroup.
E
ND OF STEPS
Example: As shown in Figure 67, the smartgroup1 interface of
ZXR10 GER router is interconnected with the st.1 interface of
ZXR10 routing switch.