EasyManua.ls Logo

Zte ZXR10 GER - Page 149

Zte ZXR10 GER
412 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 8 Smart Group Configuration
Confidential and Proprietary Information of ZTE CORPORATION 127
TABLE 151 BIND COMMAND
Command Format
Command
Mode
Command Function
interface
smartgroup<smartgrup
no>
Interface
config
This bind the link
Result: This bind the link.
.3. To configure the load sharing function on the SMARTGROUP
interface, use smartgroup load-balance command in
interface configuration mode, as shown in
Table 152.
TABLE 152 SMART GROUP LOAD BALANCE COMMAND
Command
Format
Command
Mode
Command Function
smartgroup
load-
balance
Interface
config
This configures the load sharing
function on the SMARTGROUP
interface
Result: This configures the load sharing function on the
SMARTGROUP interface.
.4. To implement the ACL function on the SMARTGROUP
interface, use ip access-group command in interface
configuration mode, as shown in
Table 153.
TABLE 153 IP ACCESS GROUP COMMAND
Command
Format
Command
Mode
Command Function
ip access-
group
Interface
config
This implements the ACL
function on the SMARTGROUP
interface
Result: This implements the ACL function on the
SMARTGROUP interface.
ND OF STEPS
Example:
Figure 72 shows the SMARTGROUP configuration example. The
fei_2/1~fei_2/3 interface of the RA is connected to the
fei_2/1~fei_2/3 interface of the RB respectively. Bind the
interfaces to the smartgroup, and connect the fei_1/1 interface
of RA and RB to the SMARTBITS tester.

Table of Contents

Related product manuals