Zte ZXR10 GER - Advertisement; Redistribute Static

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
140 Confidential and Proprietary Information of ZTE CORPORATION
Result: This enables to create multilink interface and to
enter into it.
3. To configure an IP address of an interface, use ip address
<ip-address> <net-mask> [<broadcast-address>] in
interface config mode as shown in
Table 168.
TABLE 168 IP ADDRESS COMMAND
Command
Format
Command
Mode
Command Function
ip address
<ip-
address>
<net-mask>
[<broadcast-
address>]
Interface
This configures an ip address of
an interface
Result: This configures an ip address of an interface.
4. To bind physical link of multiple E1s use multilink-group
<multilink-number> command in interface configuration
mode as shown in
Table 169.
TABLE 169 MULTI-LINK GROUP COMMAND
Command
Format
Command
Mode
Command Function
multilink-
group
<multilink-
number>
Interface This binds link to multilink
Result: This sets multiple E1 links to a group.
5. To configure end point string of multilink, use ppp multilink
endpoint string <string> command in interface
configuration mode as shown in
Table 170.
TABLE 170 PPP MULTILINK END POINT COMMAND
Command
Format
Command
Mode
Command Function
ppp multilink
endpoint
string <string>
Interface
This configures end point string
of multilink
Result: This sets end point string of multilink.
E
ND OF STEPS
Example: As shown in Figure 76, routers R1 and R2 are bound
and interconnected in channelized E1 mode. MPPP is configured.