Chapter 9 Link Protocol Configuration
Confidential and Proprietary Information of ZTE CORPORATION 143
TABLE 172 INTERFACE CONFIG COMMAND
Command
Format
Command
Mode
Command Function
Interface
<interface-
name>.
Global
configuration
This selects an interface to be
configured and to enter into
interface configuration mode
Result: This selects an interface to be configured and to
enter into interface configuration mode.
2. To configure FR encapsulation for the interface, use the
following command, as shown in
TABLE 173 ENCAPSULATION FRAME RELAY COMMAND
Command
Format
Command
Mode
Command Function
encapsulation
frame-relay
Interface
configuration
This configures an FR
encapsulation for the
interface
Result: This configures an FR encapsulation for the interface.
3. To configure an IP address of the interface, use the following
command, as shown in
Table 174.
TABLE 174 IP ADDRESS COMMAND
Command
Format
Command
Mode
Command Function
ip address
<ip-addr>
<net-mask>
[<broadcast-
addr>]
[secondary]
Interface
configuration
This configures an IP address
of the interface
Result: This configures an IP address of the interface.
4. To configure the equipment type, use the following command,
as shown in
Table 175.
TABLE 175 IP ADDRESS COMMAND
Command
Format
Command
Mode
Command Function
frame-relay
intf-type
<equip-
type>
Interface
configuration
This configures the equipment
type
Result: This configures the equipment type.
.
Note: Equipment type name can be dce, dte (by default) or
nni. Communication ends are dte and dce respectively. If one
end is configured with "nni" (network-network interface), the
other end is also configured with "nni".