Zte ZXR10 GER - Page 181

Chapter 11 Network Protocol Configuration
Confidential and Proprietary Information of ZTE CORPORATION 159
Refer to below procedure for configuring basic ARP address on
ZTE ZXR10 GER router.
Router Command Line Interface has been accessed.
1. To configure aging time of ARP table entries in ARP cache,
use arp timeout <seconds>in interface configuration mode
as shown in
Table 199.
TABLE 199 ARP TIMEOUT COMMAND
Command
Format
Command
Mode
Command Function
arp
timeout
<seconds>
Interface
This configures aging time of an
ARP table entries in ARP cache
Result: This sets aging time of ARP table entries in ARP
cache.
2. To delete all dynamic ARP table entries in Ethernet interface
ARP cache, use clear arp-cache <interface-number> in
Exec mode as shown in
Table 200.
TABLE 200 CLEAR ARP CACHE COMMAND
Command
Format
Command
Mode
Command Function
clear arp-
cache
<interface-
number>
Exec
This deletes all dynamic ARP
table entries in Ethernet
interface ARP cache
Result: This deletes dynamic arp table entries in Ethernet
interface ARP cache.
E
ND OF STEPS
Example: An ARP configuration example is given as follows.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#arp timeout 1200
Following command can be used to view an ARP table entry of a
designated Ethernet interface.
Purpose
Prerequisite
Steps
Command
Format
Command
Mode
Command Function
show arp
<interface-
number>
User
Exec
This displays an ARP table
entry of an Ethernet interface