Zte ZXR10 GER - Page 344

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
322 Confidential and Proprietary Information of ZTE CORPORATION
2. To set interface for support RSVP signaling, use mpls
traffic-eng tunnels in interface configuration mode as
shown in
Table 367.
TABLE 367 MPLS TRAFFIC INTERFACE COMMAND
Command
Format
Command
Mode
Command Function
mpls
traffic-
eng
tunnels
Interface config
This enables MPLS TE on an
interface
Result: This configures MPLS TE signaling on an
interface.
Note: RSVP is supported on GER Ethernet and Pos
interfaces.
3. To configure the maximum available bandwidth of traffic
engineering and LSP of an interface, use ip rsvp bandwidth
<max-bandwidth> [<flow-bandwidth>] in interface
configuration mode as shown in
Table 368.
TABLE 368 IP-RSVP COMMAND
Command
Format
Command
Mode
Command Function
ip rsvp
bandwidth
<max-
bandwidth>
[<flow-
bandwidth>]
Interface config
This sets the parameter for
maximum available bandwidth
Result: This configures the available bandwidth for traffic
engineering of an interface.
4. To configure the IGP to support TE, following commands are
used:
i. To define the Router of the TE, use mpls traffic-eng
router-id <interface-name> command in OSPF
configuration as shown in
Table 369.
ii. To configure TE-enabled areas, use mpls traffic-eng
area <area-id> command in OSPF config mode as shown
in
Table 369.
iii. To enable opaque feature of the OSPF, use command
capability opaque in OSPF config mode as shown in
Table 369.