Zte ZXR10 GER - Page 99

Chapter 5 System Management
Confidential and Proprietary Information of ZTE CORPORATION 77
3. Configure both TFTP Server Computer System Ethernet port
and router management Ethernet port of router in the same
network section.
Result: Different IP addresses belonging to same network
are configured.
4. View information about the currently running image ， use
show version command, as shown in
Table 67.
TABLE 67 SHOW VERSION COMMAND WINDOW
Command
Format
Command
Mode
Command Function
show
version
Exec This indicates software version of
flash and new image file present
in directory
Result: This indicates new image file present in directory.
5. Use the delete command in Exec mode to delete the old
image file zxr10.zar under the IMG directory in the FLASH
only if space is not sufficient, otherwise just change its name.
The command is shown in
Table 68.
TABLE 68 DELETE COMMAND WINDOW
Command
Format
Command
Mode
Command Function
delete Exec This deletes file present in flash
Result: This deletes old image file.
6. Copy new image file in background TFTP Server into IMG
directory in FLASH. The name of the image file is zxr10.zar.
The operation of copying the image file to the FLASH in FTP
mode is shown in
Table 69.
TABLE 69 COPY COMMAND WINDOW
Result: This copies new image file in flash.
7. Check whether the new image file exists in FLASH using
command show version in Exec mode as shown in
Table 70.
Important! If file does not exist, this indicates a copy failure.
ZXR10#copy tftp: //168.4.168.89/zxr10.zar
flash: /img/zxr10.zar
Starting copying file
.................................................................
.................................................................
......................................
file copying successful.
ZXR10#