Slot for AnybusCC fieldbus adaptersA
DeviceNet master/slave board
The DeviceNet m/s board is installed the right side of the main computer.
xx1300001968
Slot for DeviceNet m/s boardA
Termination resistors in the DeviceNet bus
Each end of the DeviceNet bus must be terminated with a 121 ohm resistor. The
two terminating resistors should be as far apart as possible.
The termination resistor is placed in the cable connector. There is no internal
termination on the DeviceNet PCI board. The termination resistor is connected
between CANL and CANH - that is, between pin 2 and pin 4 according to the
illustration below.
xx0400000674
References
For more information on how to install and configure the fieldbuses, see the
respective fieldbus application manual.
Product manual - IRB 14000 101
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
2 Installation and commissioning
2.4.5 Connecting fieldbuses
Continued
To Next Page
Loading...
