ABB IRB 14000 - Removing the Ethernet Switch

Removing the EtherNet switch
Use this procedure to remove the EtherNet switch.
Removing the body cover
NoteAction
DANGER
Turn off all:
• electric power supply
• air pressure supply
to the robot, before starting the repair work on the
robot.
1
Flange screw (10 pcs)
xx1500000525
Remove the body cover.2
xx1500000303
Removing the EtherNet switch
NoteAction
DANGER
Make sure that all supplies for electrical power
and air pressure are turned off.
1
Disconnect the connectors (cut cable ties if neces-
sary):
• A33.X2 (X2)
• A33.X3 (X3)
2
Continues on next page
Product manual - IRB 14000 373
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
4 Repair
4.7.12 Replacing the EtherNet switch
Continued