NoteAction
DANGER
Turn off all:
• electric power supply
• air pressure supply
to the robot, before starting the inspection work on
the robot.
2
Art. no. is specified in section
Required tools and equipment on
page 115.
If the lamp is not lit, trace the fault by:
• Make sure that the signal lamp is not broken.
If so, replace it.
• Inspect the cable connections.
• Inspect the cabling. Replace the cabling if a
fault is detected.
3
For details about how to replace
the signal lamp, see Installing the
signal lamp on page 80.
116 Product manual - IRB 14000
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
3 Maintenance
3.3.2 Inspecting, signal lamp
Continued
To Next Page
Loading...
