NoteAction
Spare part numbers and replace-
ment information is found in Repla-
cing the encapsulation and covers
on page 145.
Visually inspect all plastics and padding parts for
damage.
If any cover is damaged or cannot perform its
protective function for other reasons, it must be
replaced.
2
Tightening torques are specified in
Replacing the encapsulation and
covers on page 145.
Make sure that all plastic and padding covers are
fully fastened. Manually check that the parts are
not loose. Tighten, if needed.
3
120 Product manual - IRB 14000
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
3 Maintenance
3.3.4 Inspecting, plastic and padding
Continued
To Next Page
Loading...
