Elimination/ActionDescriptionWarning
Make sure not to overfill the
gearbox when filling it with oil or
grease!
Overfilling of gearbox lubricant
can lead to internal over-pres-
sure inside the gearbox which in
turn may:
• damage seals and gas-
kets
• completely press out
seals and gaskets
• prevent the robot from
moving freely.
xx0100000002
Do not overfill
After filling, verify that the level
is correct.
After filling, verify that the level
is correct.
The specified amount of oil or
grease is based on the total
volume of the gearbox. When
changing the lubricant, the
amount refilled may differ from
the specified amount, depending
on how much has previously
been drained from the gearbox.
xx0100000004
Specified amount de-
pends on drained
volume
When draining the oil make sure
that as much oil as possible is
drained from the gearbox. The
reason for this is to drain as
much oil sludge and metal chips
as possible from the gearbox.
The magnetic oil plugs will take
care of any remaining metal
chips.
xx0100000003
Contaminated oil in
gear boxes
58 Product manual - IRB 14000
3HAC052983-001 Revision: D
© Copyright 2015 - 2016 ABB. All rights reserved.
1 Safety
1.4.6 WARNING - Safety risks during work with gearbox lubricants (oil or grease)
Continued
To Next Page
Loading...
