Acteon X-MIND prime 3D ceph - Page 34

Service Manual - Description
SERVICE MANUAL • X-MIND prime 3D • (19) • 11/2019 • NXMPEN080A
32
4.2.2.1 MCU board DIP Switches
The following table shows the different modalities of DIP Switches present on the
MCU board.
Code (*)
1
2
3
Function
0
ON
ON
ON
Normal mode
1
OFF
ON
ON
EEPROM reset (see paragraph 9.2.2.1)
2
ON
OFF
ON
Exhibition demo mode: allows rotation
without X-ray emission (see paragraph
7.16.2)
4
ON
ON
OFF
- Axis alignment service mode: used to
check laser centering rotating between
the arm 0°, 90° and 180° positions by
pressing >0<.
5
OFF
ON
OFF
- MCU bootloader forced by DIP switches
* It is possible to see this code by keeping the MCU SD card log (see paragraph
11.2.1.2)
Figure 3
OFF
ON