Acteon X-MIND prime 3D ceph - Page 4

Service Manual - Introduction
SERVICE MANUAL • X-MIND prime 3D • (19) • 11/2019 • NXMPEN080A
2
5.7 Reference standard 54
6. PRE-INSTALLATION 56
6.1 Electrical setting up 57
6.2 Packaging 59
6.3 Space requirements 61
6.4 Drilling templates 62
7. INSTALLATION 68
7.1 Mechanical installation 69
7.2 Fuses installation 91
7.3 Electrical connections 92
7.4 How to mount the covers 97
7.4.1 Wall plate cover 97
7.4.2 Upper cover 98
7.4.3 Ceph arm covers 99
7.4.4 Temple supports 100
7.5 Unit full installed 101
7.6 How to position the cables 101
7.7 PC configuration 102
7.7.1 Network Interface board configuration 102
7.7.2 3D sensor Network Interface board configuration 106
7.8 Software installation 110
7.9 Detector Calibration files installation 112
7.10 Verification of the PANORAMIC function 113
7.11 Verification of 3D function 116
7.12 Verification of CEPH function 119
7.13 Verification of exposure parameters 123
7.13.1 Verification of Exposure parameters with invasive method 124
7.13.2 Verification of Exposure parameters with NON invasive method 128
7.14 Storing of automatic exposure parameters 130
7.14.1 Table of pre-set anatomic parameters 132
7.15 Data backup 135
7.16 Exhibition mode setup 136
7.16.1 Graphical User Interface (G.U.I.) demo (without unit connected) 136
7.16.2 Unit movements demo (without PC connection) 137
8. SERVICE PROGRAMS DESCRIPTIONS 142
8.1 Network setting 144
8.2 Exposition 145