11.1.1
MCU Firmware upgrade 226
11.1.2
CCU Firmware upgrade 230
11.2
Checks, settings and adjustment 234
11.2.1
Logs files recover 234
11.2.2
RAW files recovery 240
11.2.3
24V Power supply check 241
11.2.4
Network interface board drivers upgrade 243
11.2.5
EEPROM Memory values verification and modification 247
11.2.6
3D Sensor static IP address setting 249
11.2.7
Ceph sensor IP address modification 251
11.2.8
MCU IP address modification and factory reset 253
11.2.9
Primary collimator alignment 255
11.2.10
3D Reconstruction adjustment 265
11.2.11
Ceph Axis alignment 269
11.2.12
How to remove slight vertical lines on HD and HS ceph images 294
11.3
Parts replacement 308
11.3.1
Fuses replacement 308
11.3.2
MCU board replacement 310
11.3.3
A11 CCU board replacement 312
11.3.4
A2 Generator board replacement 312
11.3.5
A12 Collimator driver board replacement 312
11.3.6
A13 CEPH driver board replacement 312
11.3.7
A14 Ceph sensor board replacement 312
11.3.8
Ceph sensor replacement 312
11.3.9
3D sensor replacement 312
11.3.10
Tube head replacement 315
11.3.11
Column replacement 320
11.3.12
Chin support replacement 326
12.
SCHEMATICS AND DRAWINGS 331
13.
SPARE PARTS 350
13.1
Top side of the unit 350
13.1.1
Electrical and mechanical part 350
13.1.2
Cable 352
13.2
Rotating arm 353
13.3
Collimator 355
13.4
Chin support 356
13.5
UP/DOWN Column 357
13.5.1
Electrical and mechanical part 357
13.5.2
Cable 359
13.6
TOP side / Rotation arm cables 359
To Next Page
Loading...
