ADCMT 6240B User Manual

6240B DC Voltage Current Source/Monitor Operation Manual
4.2.6 MENU Key (Parameter Setting)
4-13
PARAMETER Loads or saves the setting parameters.
Parm Load Loads the setting parameters from the non-volatile memory.
Not displayed on the menu screen in Operate status.
Load0: Loads the data from area 0 of the non-volatile memory
as setting parameters.
Load1: Loads the data from area 1 of the non-volatile memory
as setting parameters.
Load2: Loads the data from area 2 of the non-volatile memory
as setting parameters.
Load3: Loads the data from area 3 of the non-volatile memory
as setting parameters.
Ld Dflt: Loads the factory default parameters as setting
parameters.
Parm Save Saves the setting parameters to the non-volatile memory.
Save0: Saves the current setting parameters to area 0 of the
non-volatile memory.
Save1: Saves the current setting parameters to area 1 of the
non-volatile memory.
Save2: Saves the current setting parameters to area 2 of the
non-volatile memory.
Save3: Saves the current setting parameters to area 3 of the
non-volatile memory.
Sv Dflt: Saves the factory default parameters to all the areas 0 to
3.
PON. Load Selects the parameter loading condition at power ON.
P.OFF: Starts up using the parameters when the instrument was
last turned off.
Load0: Starts up using the parameters saved in area 0 of the
non-volatile memory.
I/F Selects or sets the interface.
I/F BUS Selects the interface.
GPIB: Selects the GPIB interface.
USB: Selects the USB interface.
GPIB Adr Sets the GPIB address from 0 to 30.
Displayed only when the GPIB interface is selected.
USB Id Sets the USB ID from 1 to 127.
Displayed only when the USB interface is selected.

ADCMT 6240B Specifications

General

Brand	ADCMT
Model	6240B
Category	Measuring Instruments
Language	English