ADCMT 6240B User Manual

6240B DC Voltage Current Source/Monitor Operation Manual
6.7.3 Remote Command List
6-29
Sweep Random sweep
memory data
N [adr]
P
Random sweep memory data setting starts from the N
command and completes at the P command.
N<adr>,SVR<n>,SOV<data1>,SOV
<data2>,...,P (for voltage setting)
N<adr>,SIR<n>,SOI<data1>,SOI
<data2>,...,P (for current setting)
adr: Memory address (0 to 7999)
data1:
Voltage or current source value at adr
data2: Voltage or current source value at
adr+1
0
0
*6
N? [adr] Response: N<adr>,SVR<n>,SOV  <data>,P
(For voltage source value)
N<adr>,SIR<n>,SOI  <data>,P
(For current source value)
adr: <dddd>
n: <d>
data: <d.ddddE  d>
*1
NP? Query of the random sweep memory setting status
Response: 0
... Random sweep memory setting complete
1... Random sweep memory is being set
0
RSAV Saves the random sweep data.
RLOD Loads the random sweep data.
RCLR Initializes the random sweep data. (Data saved in the
memory is not initialized.)
Pulse sweep base
value
BS [data] data: Pulse sweep base value
0
BS? Response: BS ± <d.ddddE ± d>
*1
Bias value SB [data] data: Bias value
0
SB? Response: SB ± <d.ddddE ± d>
*1
RTB
(Return To Bias)
RB0 OFF (Stays at the final value when sweep stops.)
RB1 ON (Returns to the bias value when sweep
stops.)
RB? Query of the RTB
Response: RB0 or RB1
*1: The decimal point position in response varies depending on the setting value.
For the source value, limit value, and time parameter setting ranges, refer to the specifications.
*6: Not initialized by the RINI or *RST command.
Item Command Description
Default Operation
Power ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS
Note:
1. When no source range is specified, the optimal range is
set.
2. Source values different from the present source function
cannot be set.

ADCMT 6240B Specifications

General

Brand	ADCMT
Model	6240B
Category	Measuring Instruments
Language	English