ADCMT 6240B - Page 65

6240B DC Voltage Current Source/Monitor Operation Manual
2.2.3 Menu Operation
2-29
1) Hold Time Hold time
1 ms to 60 s
Numeric
2) Src Delay Source delay time
30 s to 59.998 s
Numeric
3) Meas Delay Measurement delay time
50 s to 59.998 s
Numeric
4) Pls Width Pulse width
50 s to 59.998 s
Numeric
5) Period Period (pulse cycle)
500 s to 60 s
Numeric
6) A.Rng Delay Auto range delay time
0 ms to 500 ms
Numeric
D) TIME
(c)
Category level
Select level Input/Run level
E) MEASURE
Parameter
type
1) Auto Zero Measurement auto zero
On/Off
Select
2) Integ Time Integration time
100 s / 500 s / 1 ms / 5 ms / 10 ms / 1 PLC / 100 ms / 200 ms
/ S/H
* S/H is available only when the output mode is set to the
pulse mode, the pulse sweep mode, or low-resistance meas-
urement pulse mode.
Select
3) Mesure SW Measurement ON/OFF
On / Off
Select
4) Disp Digit Number of measurement digits
5 digits / 4 digits / 3 digits
Select
5) Disp Unit Switching the unit display
Prefix / Exponent
Select
6) Mfunc Link Measurement function link mode
On / Off
Select
(b)
F) MEMORY
1) Store Mode Measurement data memory
Off / Normal / Burst
Select
2) Mem Recall Measurement data memory recall
Recall data number setting
Numeric
3) Mem Clear Measurement data memory clear
Press [ENTER] to run.
Run