Chapter 10 10-7
Service Key Menus and Error Messages
Service Key Menus
Edit List Menu
To access this menu, press
and then press one of the following: or
or .
Self Diagnose Softkey
You can access the self diagnosis function by pressing
. This function examines, in order, the pass/fail status of all internal
tests and displays NO FAILURE FOUND if no tests have failed.
If a failure is detected, the routine displays the assembly or assemblies most probably
faulty and assigns a failure probability factor to each assembly.
Table 10-4 Edit List Menu Keys
Key GPIB
Mnemonic
Description
N/A Selects a segment (frequency point) to be edited, deleted
from, or added to the current data table. Works with the
entry controls.
SEDI[D] Allows modification of frequency, cal factor and loss values
previously entered in the current data table.
SDEL Deletes frequency, cal factor and loss values previously
entered in the current data table.
SADD Adds new frequency, cal factor and loss values to the current
data table up to a maximum of 12 segments (frequency
points, PTS).
CLEL
Deletes the entire current data table (or list) when is
pressed. Press to avoid deletion.
EDITDONE Selects whether or not to use the power loss table for a power
meter calibration.
System
To Next Page
Loading...
Need help?
General
