Load mode
106
● To load a single sample
5. Move the cursor to the file list block, and select the sample file that you want to
load.
6. Press the [F6] key (DO IT).
The selected sample will be loaded.
● To load multiple samples
7. After step 4, move the cursor to the file list block, and select the folder that
contains the sample files you want to load.
8. Press the [F6] key (DO IT).
The Load Folder popup window will appear.
A Load field
Selects the type of file that will be loaded.
B Replace same sample in memory field
Specifies what will happen if memory contains an identically-named sample.
C [F1] key (CANCEL)
Cancels the load operation and closes the popup window.
D [F3] key (CLEAR)
Clears the internal memory, and then loads the samples.
E [F5] key (DO IT)
Loads the samples.
9. Make sure that the Load field is set to SAMPLES.
If a different setting is selected, turn the [JOG] dial to select SAMPLES.
10. Move the cursor to the Replace same sample in memory field, and specify what
will be done if memory contains identically-named samples.
YES........................The samples in memory will be overwritten.
NO..........................Identically-named sample files will not be loaded.
11. To load the samples, press the [F5] key (DO IT).
When the samples have been loaded, the popup window will close.
Hint: By pressing the [F3] key (CLEAR) instead of the [F5] key, you can clear the memory before
loading the samples.
3 4 5
1
2
To Next Page
Loading...
Need help?
General
