Mixer mode
136
Mixer mode
Part page
Adjusting the mix parameters for each part
Here you can view the parts that are included in the currently selected multi, and adjust
the volume, pan, and effect send level.
To access this page........[MIXER] key
A Mixer block
Mixer block
Here you can adjust the volume, pan, and effect send level for each part.
A Part number field
Move the cursor to this field and turn the [JOG] dial to select the number of the part you
want to control. If there are more parts than can be displayed in one screen, turn the
[JOG] dial to scroll the screen to left or right.
B Fx field
Indicates the effect send level of each part. Turn the [Q1] knob of the Q-LINK section to
adjust the effect send level of the currently selected part.
C Pan field
Indicates the pan setting of each part. Turn the [Q3] knob of the Q-LINK section to adjust
the pan of the currently selected part.
D Level field
Indicates the level of each part. Use the [Q5] slider of the Q-LINK section to adjust the
volume of the currently selected part.
Hint: These parameters are linked with the parameters of the multi, so that editing one will change
the other.
The settings of the Part Mixer are stored in the multi. If you want to keep the settings you edit, you
must save the multi.
The [ACTIVE] keys of the [Q1]/[Q3] knobs and [Q5] slider will automatically be turned off when you
enter Mixer mode, and will return to their previous state when you exit Mixer mode.
1
1
2
3
4
To Next Page
Loading...
Need help?
General
