Effect mode
138
1–8......................... The signal will be output in monaural to individual outputs 1–8.
(This can be selected only if the individual output option is installed.)
D Stereo link field
Switches the stereo link function on/off for effects 1/2 or 3/4. If stereo link is turned on,
effects 1–2 or effects 3–4 can be used together as a stereo-in/stereo-out effect. When ste-
reo link is on, the effect 2 and 4 fields will be empty; the same effect types as for effects
1 and 3 will be selected, and the effect parameters will also be shared.
■ Switching the effects to stereo input
1. Press the [EFFECT] key.
The Select page will appear.
2. Move the cursor to the Stereo link field for effects 1/2, and turn the [JOG] dial
to switch the setting on.
When the Stereo link field is on, effects 1 and 2 will be linked, and can be used as a ste-
reo-in/stereo-out effect. If desired, you can link effects 3/4 in a similar way.
3. Move the cursor to the effect 1 Effect field, and turn the [JOG] dial to access
the Select Effect Type popup window.
4. Turn the [JOG] dial to select an effect type, and press the [F6] key (SELECT).
The popup window will close, and the selected effect type will be assigned to effects 1/2.
5. Make sure that the effect 1 input source is set to SEND A, and the effect 2 input
source to SEND B.
With these settings, the L and R signals from the part will be sent to effects 1 and 2
respectively.
6. As necessary, select the output destination for the effect.
7. Press the [MULTI] key, and then press the [F2] key (MIX).
The Multi mode Mix page will appear.
8. Move the cursor to the Send field of the part for which you want to use the
effect, and turn the [JOG] dial to set the value to AB.
The signal of the part will be sent to effect buses SEND A/B. The L signal of the part will
be sent to effect 1, and the R signal will be sent to effect 2.
9. As necessary, adjust the pan and effect send level of the part.
To Next Page
Loading...
Need help?
General
