Q-LINK setup page
231
F MIDI field
Specifies the MIDI channel on which control change messages will be received. If you
select Part for the PART/FX field, this will automatically be set to the MIDI channel of
that part.
■ Assigning parameters to the Q-LINK knobs/sliders
Here’s how to assign the desired parameters to the knobs and sliders of the Q-LINK sec-
tion.
1. Press the Q-LINK section [SETUP] key.
The Q-LINK setup page will appear. Press the [F1] key (KNOB) to assign a parameter
to a knob, or press the [F2] key (SLIDER) to assign a parameter to a slider. The corre-
sponding page will appear.
2. Move the cursor to the Multi field and select the multi for which you want to
make settings.
Since Q-LINK settings are stored as part of the multi, you must first use the Multi field
to select a multi.
3. Move the cursor to the destination block of the knob or slider that you want to
assign. Move the cursor to the left PART/FX field and select the element you
want to control.
You can select whether to control a part (PART) or an effect parameter (FX).
4. Move the cursor to the right field. Specify the part number if you selected PART
in step 3, or specify the effect number if you selected FX.
5. Move the cursor to the Assign field and select the parameter that you want to
control from the knob or slider.
If you selected PART in step 3, you can choose from the same parameters as for a pro-
gram modulation destination.
If you selected FX in step 3, you can choose from the effect parameters of the corre-
sponding effect.
6. Move the cursor to the Type field and turn the [JOG] dial specify how the value
will be modified; OFFSET (adjust the value in the positive or negative direction,
relative to the current setting) or REPLACE (set the value according to the
position of the knob or slider, regardless of the current setting).
7. Move the cursor to the Range field and turn the [JOG] dial to specify the range
over which the value will be modified.
8. Make settings in the same way for other knobs and sliders.
9. When you have finished making settings, save the multi as necessary.
10. Turn on the [ACTIVE] key for the Q-Link knobs and sliders you want to use.
Nothing will happen if you move a knob or slider whose [ACTIVE] key is off.
11. Start the sequence or song, and operate the knobs and sliders of the Q-LINK
section.
The corresponding program or effect will be modified.
To Next Page
Loading...
Need help?
General
