Akai MPC 4000 User Manual

Program mode
222
5. If you want to use a modulation source other than velocity to switch between
zones, move the cursor to the Range field and press the [WINDOW] key.
The Program Modulation popup window will appear.
6. Move the cursor to an empty Source field, and select the desired modulation
source.
7. Move the cursor to the Destination field at the right, and choose ZONE SELECT
as the modulation destination.
8. Move the cursor to the Depth field, and set the value to 100.
9. Press the [WINDOW] key.
You will return to the Zone page. Now you can use the modulation source you selected
in step 6 to switch between zones 1 and 2. While playing the pads (notes), make fine
adjustments to the settings of the Range field.

Akai MPC 4000 Specifications

General

Polyphony	64 voices
RAM	272 MB (expandable to 512 MB)
Pads	16 velocity and pressure-sensitive pads
MIDI	2 MIDI inputs, 4 MIDI outputs
Sampling Frequency	44.1 kHz
Display	240x64 backlit LCD
Effects	4 internal effects processors
Storage	Internal Hard Drive
Sequencer	300, 000 notes capacity
Filter	Multi-mode filter (Low Pass, High Pass, Band Pass, Band Boost, Band Reject)