Pad Assign Functions
246
Sensitivity page
Adjusting the sensitivity of the pads
Here you can adjust the velocity sensitivity of the sixteen pads.
A Pad block
Functions
• [F1] key (CURRENT)
Displays the Current page.
Pad 1–16 block
Here you can adjust the sensitivity of the sixteen pads.
A Sensitivity field
Specifies the sensitivity of the pad to the force with which you strike it.
A setting of 100% is the normal sensitivity. Increasing the setting beyond this value will
cause a higher velocity value to be transmitted even if you do not strike the pad as
strongly.
B Bar display
Shows the pressure value of each pad.
C Velocity field
Shows the velocity value that is produced when you strike the pad.
1
3
2
1
To Next Page
Loading...
