The Q-LINK function
234
6. When you have finished making settings, save the sequence as necessary.
The contents of the Q-LINK sequence are saved as part of the sequence.
7. Press the [Q-LINK SEQUENCE] key to play back the Q-LINK sequence.
The LED will light, and Q-LINK sequence playback will be enabled.
8. If you want to switch the knobs and sliders on/off individually, access the
Q-LINK sequence page, and press the [F3]–[F6] keys.
Even if the [Q-LINK SEQUENCE] key is on, knob/slider movements will not be output
if the [F3]–[F6] keys are off.
9. Start the sequence or song.
The knob/slider movements recorded in the Q-LINK sequence will be reproduced.
10. If you want to operate a knob/slider manually while the sequence/song is
playing, turn on the [ACTIVE] key for that knob/slider.
When you turn on the [ACTIVE] key, the movements recorded in the Q-LINK sequence
will be disabled, and the movement of the knob/slider will take priority.
Note: A Q-LINK sequence contains knob/slider positions, not event values. This means that the result
may change depending on the output destination that is assigned to the knob/slider or the type of event.
When you play back a Q-LINK sequence, make sure that the appropriate multi is selected.
To Next Page
Loading...
