Akai MPC 4000 User Manual

Check the included items
251
Appendix: Installing storage devices (for service engineers)
This appendix explains how to install storage devices (ATA hard disk, CD-ROM drive,
Zip drive, etc.) in the MPC4000.
Check the included items
The following items are included with the MPC4000 for use when installing storage
devices. Check to make sure that no items are missing.
■ Cables
• Flat cable for ATA drive
• Power cable for drive (without ferrite core)
• Power cable for drive (with ferrite core)
• Analog audio cable for CD-ROM
• Digital audio cable for CD-ROM
■ Other items
• Screws (inch) for attaching hard disk (4 pcs.)
• Screws (metric) for attaching hard disk (4 pcs.)
• Screw hole plugs (4 pcs.)
Opening the top panel
When installing a storage device, use the following procedure to open the top panel of
the MPC4000.
1. Loosen the screws that fasten the side panels (four on each side, left and right),
and remove the side panels.
2. Remove the screws (five on each side, left and right) that fasten each side of the
top panel to the chassis.

Akai MPC 4000 Specifications

General

Polyphony	64 voices
RAM	272 MB (expandable to 512 MB)
Pads	16 velocity and pressure-sensitive pads
MIDI	2 MIDI inputs, 4 MIDI outputs
Sampling Frequency	44.1 kHz
Display	240x64 backlit LCD
Effects	4 internal effects processors
Storage	Internal Hard Drive
Sequencer	300, 000 notes capacity
Filter	Multi-mode filter (Low Pass, High Pass, Band Pass, Band Boost, Band Reject)