Sample mode
168
Loop block
Here you can switch loop playback on/off, and specify the points at which the loop will
start and end.
A Lp Start field
Specifies the point at which loop playback will start (loop start point), in units of one
sample.
B Lp end field
Specifies the point at which loop playback will end (loop end point). By moving the cur-
sor to END and turning the [JOG] dial, you can select how the loop end point is dis-
played.
• END.............................Number of samples from the beginning of the sample
• LENGTH.....................Number of samples from the start point
• TIME ...........................Time from the start point
C Play mode field
Selects whether the sample will be looped, and how the sample will play. If you move the
cursor to this field and press the [WINDOW] key, the Play Mode popup window will
appear, allowing you to set the sample playback method in greater detail.
• Play mode field
This is the same parameter as the Play mode field of the Loop block.
• Repeat field
Specifies the number of repeats. If this is set to HOLD, repeats will continue indefi-
nitely.
• Loop type field
Selects how playback will occur if the key is released while the loop region is playing.
You can select LOOP IN RELEASE (decay while playing the loop region) or LOOP
UNTIL RELEASE (decay while playing the sample following the loop end point).
• Direction field
Selects the direction of loop playback. You can select FORWARDS (play repeatedly
in the forward direction from the loop start point to the loop end point) or ALTER-
NATING (play between the loop start point and loop end point, alternating between
forward and backward playback).
1 2
3
To Next Page
Loading...
Need help?
General
